Adjustable Base & Split Beds
Keep presence readings accurate even when the bed frame moves. This guide covers mounting, cable management, and calibration tweaks for adjustable platforms.
Hardware Prep
Power down the adjustable base and move it to the flat position.
Attach the angled bracket to the enclosure so the mmWave cone clears the moving rails.
Snap the strain-relief clip on the USB-C cable to prevent tugging during motion.
Mount + Cable Management
Use the adhesive flex mount on the stationary cross member, not the moving lift arms.
Route the cable through the included braided sleeve and zip-tie it alongside factory harnesses.
Test full articulation of the base to ensure nothing snags or pinches.
Calibration Adjustments
Increase Absolute Clear Delay to 45s to account for base motion after exiting the bed.
Enable "Motion Dampening" in the console if the base vibration triggers false readings.
Log one full night and check the confidence chart before deploying new automations.